7 min
185 front coils, arms, and bushes
Coil-spring front and control-arm bushes on the third-generation Surf, the SSR spring line that is actually sourced, and the torsion-bar 130 parts that do not fit.
Summary: the third-generation Surf kept a double wishbone at the front and replaced torsion bars with coil springs (Toyota Global 185-series launch). A front coil you can see in the guard is this job. A torsion bar running back from the lower arm is the previous wagon (Toyota Global 130-series launch). Bushes, ball joints and springs are separate lines even when a seller calls the tin a front-end kit.
The genuine spring number on this page is scoped to KZN185 SSR grades, not to every letter on the shell (PartsNext front coil). Rear coils, the panhard rod and shock length are the 185 rear coils guide. The lower 2WD grade from August 1998 is the Sports Runner guide (Toyota Global 185-series launch). Spring rate, free length and lift in millimetres are unconfirmed here. Check your workshop manual and measure the spring you remove.
Confirm you are on a coil front
- Coil spring between the lower arm and the body, because torsion bars were replaced on this generation (Toyota Global 185-series launch).
- KZN185, RZN185 or VZN185 on the plate for the common petrol and 1KZ diesel shells (Toyota Global 185-series launch).
- KDN185 is the later common-rail diesel on this body from July 2000 (Toyota Global 185-series launch). Do not assume the SSR 1KZ spring number covers it.
- Sports Runner from August 1998 sits lower as a 2WD wagon (Toyota Global 185-series launch). Treat its springs as their own question, not as an SSR 4WD pair.
Spring, bush, and ball joint
A nose that has settled evenly is often springs. A knock from one corner is often a bush or a ball joint, and a spring will not stop it. A lean to one side can be a broken coil, a tired bush that has let the arm sit wrong, or a previous owner who mixed springs. Photograph both front springs from the same angle before you buy one side only.
Wide-body flares change the look of the guard and not the existence of the coil. Whether a wide-body SSR and a normal-body wagon share a spring rate is unconfirmed on the number below. Read 185 wide-body grades for the body split, then match the spring line to the letters and the grade you actually have.
Aftermarket bushes aimed at this shell are not a 130 torsion-bar bush with a new label. If a line also mentions Prado, that mention is not proof the bush is correct for your Surf, and it is not an invitation to order Prado arms. Match the third-generation letters on your plate. Torque on arm bolts and ball joints is unconfirmed here. Check your workshop manual. Have the alignment done once the bolts are tight.
Numbers that are actually sourced
Part: Front coil
Number: 48131-35130
What it fits: Japan Hilux Surf KZN185 SSR-G, SSR-X and SSR-V (PartsNext front coil). Other letters on this shell are not on that line.
Part: Control-arm bushes
Number: W53377A / W53529
What it fits: Control-arm bush category for Hilux Surf N180-185 (Whiteline 185 control-arm bushes).
Part: Upper arm bush
Number: 45764
What it fits: Hilux 4 Runner 185 frames, with Prado 90 also mentioned on the same line (4WheelHouse Nolathane upper bush). Confirm the 185 fit before you treat the Prado mention as your wagon.
| Part | Number | What it fits |
|---|---|---|
| Front coil | 48131-35130 | Japan Hilux Surf KZN185 SSR-G, SSR-X and SSR-V (PartsNext front coil). Other letters on this shell are not on that line. |
| Control-arm bushes | W53377A / W53529 | Control-arm bush category for Hilux Surf N180-185 (Whiteline 185 control-arm bushes). |
| Upper arm bush | 45764 | Hilux 4 Runner 185 frames, with Prado 90 also mentioned on the same line (4WheelHouse Nolathane upper bush). Confirm the 185 fit before you treat the Prado mention as your wagon. |
What not to bolt on
Part: 130 upper bush
Number: SuperPro 130
What it fits: LN130, VZN130 and YN130 among 1988–1996 4 Runner frames (ID Workz SuperPro upper arm bush).
Part: 130 lower arm
Number: SH05106
What it fits: LN130 and KZN130 lower arm (RoughTrax lower wishbone).
Part: Rear coils
Number: 185 rear
What it fits: Rear spring and shock hardware for this generation (JP-CarParts 185 rear suspension). Not a front coil.
Part: Leaf eyes
Number: Leaf kit
What it fits: LN60, LN61, YN60 and YN63 leaf eyes (Car Toys leaf-eye kit).
Part: 60 torsion bar
Number: 48161-35110
What it fits: YN61 torsion bar from August 1985 through March 1989 (PartsNext 60 torsion bar).
| Part | Number | What it fits |
|---|---|---|
| 130 upper bush | SuperPro 130 | LN130, VZN130 and YN130 among 1988–1996 4 Runner frames (ID Workz SuperPro upper arm bush). |
| 130 lower arm | SH05106 | LN130 and KZN130 lower arm (RoughTrax lower wishbone). |
| Rear coils | 185 rear | Rear spring and shock hardware for this generation (JP-CarParts 185 rear suspension). Not a front coil. |
| Leaf eyes | Leaf kit | LN60, LN61, YN60 and YN63 leaf eyes (Car Toys leaf-eye kit). |
| 60 torsion bar | 48161-35110 | YN61 torsion bar from August 1985 through March 1989 (PartsNext 60 torsion bar). |
Letters the spring line does not automatically cover
RZN185 is the 2.7 petrol and VZN185 is the 3.4 petrol on this body (Toyota Global 185-series launch). The front-coil number in the table is SSR-G, SSR-X and SSR-V on KZN185, and using it on a petrol plate, a KDN185 plate, or a Sports Runner is unconfirmed (PartsNext front coil). Photograph the spring stamp or the tag if one is still there.
KDN185 from July 2000 shares the shell and not the 1KZ service parts (Toyota Global 185-series launch). Read the later diesel versus earlier diesel guide before a diesel parts order drifts from springs into belts and filters. The coil front is still a coil front. The spring part number is a separate question.
A 130 torsion-bar crank does not set ride height here. People still search "torsion bar" because the previous wagon taught them that habit. If your guard has a coil, stop and use this page. The previous front is the 130 front suspension guide.
How a spring change actually goes
Front coils on a wishbone store enough energy to injure you. Use a spring compressor that is rated for the job, or leave the swap to a workshop that does. This page does not give compressor settings or bolt torques. Check your workshop manual. A hired compressor from a parts store is still your risk if the claws slip.
Mark which spring came from which side. A pair that looks the same can already be a mix of a sagged original and a previous replacement. Seat the new spring in the lower-arm pocket the way the old one sat, with the tail of the coil in the step if the arm has one. Brake hoses and ABS wires, where fitted, get moved aside on purpose, not pinched under the arm when it goes back.
Bush bolts that pass through a rubber or polyurethane sleeve should be tightened at ride height, with the weight of the wagon on the arm. Tightening them on a hanging wheel pre-loads the bush and tears it. That procedure's torque is unconfirmed here. Check your workshop manual. Then book the alignment. Camber and castor figures are unconfirmed on this page.
Shock absorbers on the front are not the coil. A blown front shock lets the coil do all the work and the wagon will bounce once and keep going. Front shock numbers for each grade are unconfirmed here. Photograph the shock body and the top mount. Rear shock length and the panhard rod stay on the 185 rear coils guide.
What to photograph
- Build plate with the letters and the build month (Toyota Global 185-series launch).
- One front coil in place, and the matching corner on the other side.
- Any paint mark or tag on the spring.
- The upper arm bush and the ball-joint boot if the complaint is a knock rather than a sag.
- Flares, so wide body is not confused with a normal guard when you order body parts on the same visit.
Frequently asked questions
- Does 48131-35130 fit every third-generation wagon (PartsNext front coil)? Petrol letters, the later common-rail diesel, and Sports Runner are unconfirmed on that number.
- Why does a bush line mention Prado? The upper-bush line also mentions Prado 90 (4WheelHouse Nolathane upper bush). That is not proof you should order Prado arms for a Surf.
- Can I use 130 SuperPro bushes? Those cover LN130-family frames from 1988–1996 (ID Workz SuperPro upper arm bush).
- How much lift is safe? Unconfirmed here. Measure, and do not invent a millimetre figure from a forum.
- What bolt torque? Unconfirmed here. Check your workshop manual.
- Is the rear coil the same part? No. Rear hardware is a different diagram (JP-CarParts 185 rear suspension).
Have the plate handy?
Add the model code on the fitment summary form. A part that is not in the tree can still be described there.
Fitment summary form